When it comes time to clean your wood deck in preparation for refinishing, a chemical deck brightener applied by hannike 2 in 1 shorts jordan max aura 4 zapatiilas nike stefan beghelli intelligent pila batteria litio 7 2v 13ah 8132 tarka do cukinii Amazon kamery lučko tenson kappa dam Sweden spalding tienda oficial falke elværktøj rystepudser test falke elværktøj rystepudser test fortela shop online levi’s slim taper lo ball Netherlands nfl jerseys cheap chanel torebki Poland касичка за пари с брояч d may not do the job as well as a power washer.
A pressure washer is a simple machine that can clean effectively with simply water. However, if not employed appropriately, it might wreck your deck. This is a tool with enough power to etch brick, but it may also be delicate enough to wash siding in the proper hands. You can badly etch the wood and cause the fibers to splinter if you use too much jet pressure or set the tip too close to the surface of your deck. Allow some time to become acquainted with the machine before unleashing its cleaning power on your deck.
Choose a Tip and a Pressure Setting
Select the suitable spray tip and pressure setting for your application:
Use the smallest amount of pressure that is still effective.
Soft woods (such as cedar or pine) should be pressured at 500 to 600 pounds per square inch (psi); harder woods may withstand more pressure, but not more than 1,200 psi.
Use a fan tip with a spread of 40 to 60 degrees. If used properly, a revolving tip is also appropriate.
Experiment with the Pressure Washer Settings
It takes some practice to use a pressure washer. In an inconspicuous spot, such as a stair tread or a corner, test your pressure and its effectiveness. A stair tread is easier to replace than a surface deck board if you need to replace a piece of wood because you etched it.
Begin at a pressure of 500 to 600 psi. Gradually increase the pressure until you find the right level for proper cleaning.
Deck Power Washing
Engage the trigger while holding the wand tip a few feet away from the deck surface, then lower the wand closer as necessary. If you come any closer than 6 inches, you risk damaging the wood.
Sweep the deck and avoid the tendency to swivel your arm, which will result in an irregular distance between the spray point and the deck surface. By moving your arm laterally back and forth, you can try to maintain a consistent distance.
From the house outward, clean the deck boards. Working with the grain, feather the spray lengthwise, parallel to the deck boards, and slightly overlapping each area. The goal is for even cleaning with no “hot spots” or apparent cleaning edges.